Disclaimer

The information on SteelInfo is provided free of charge for general information. While every effort has been made to make it accurate, no warranty is given about the accuracy, completeness or suitability of any data, drawing, calculation or tool on this site.

Section properties are calculated from nominal dimensions and may differ slightly from manufacturers' published values (see data sources & verification). Design capacities are a simplified implementation of AS 4100 and do not cover every clause, load case or member condition. The calculators are aids, not a substitute for the judgement of a suitably qualified engineer, who remains responsible for the design. Check all information against current manufacturer literature and the relevant Australian Standards.

To the extent permitted by law, SteelInfo and its operators accept no liability for any loss or damage arising from the use of this site.

Product names and Standards referred to are the property of their owners. SteelInfo is not affiliated with any steel manufacturer or with Standards Australia.